Reshare (0 0 2) is usually needed if you are sharing with clients outsite your house. Thats ok, because you dont need reshare in your house. Scan the system for compatible elements and open them with the built-in editor. If you have server with only hop1 cards, you can just use 1 0 0Ġ 0 1 means that your receivers cannot share to other receivers. Cccam config editor software social advice. It works just fine! If you want faster zapping, then i recommend that you setup oscam.dvbapi file!Ģ 0 0 means that your receiver will get your local cards (if you have them), hop 1 and hop 2 cards. after successful download you will be promoted to intall the config lect yes to install. now click exit from your remote control and select download cam config. I have CCcam.cfg configured with two lines N & C and works without problems. Then from the top of it in File Name write CCcam.cfg and save it.

At the bottom there is a section called Save As Type, change it to All Files. Now from the top left side of your text document click File > Save As. select yes to install the cccam 2.0.4 on your box. Note: usual format of CCcam lines is C: server port user pass. This config is basic but you dont need additional (more advanced) settings. after successful cccam 2.0.4 files download, you will see this indicator. User = test #You will have to create F line in CCcam.cfg with username and password that you used here! If OScam and CCcam runs on same receiver, just use 127.0.0.1 instead of regular .x IP address! Protocol which is used between OScam and CCcam is good old CCcam 🙂ĭevice = 192.168.1.119,12333 #Change these two settings according to your setup. It is intended for people who have CCcam central server (Linux PC for example) and receivers with OScam which act as clients.